Skip to content

Free standard shipping on orders over 49 US Dollars. All prices on this site are in US Dollars.

Checkline
00 items in cart
A moulded corner guard fitted to the bottom corner of a hard-shell case, its lip wrapping both faces.
Three panels: a bare case corner, the guard aligned above it, the guard seated on the corner.
Three panels: a bare case corner, the guard aligned above it, the guard seated on the corner.
Cases stacked four high in a baggage holding area, the bottom case compressed under the load.
Cases stacked four high in a baggage holding area, the bottom case compressed under the load.

C · Corner & Edge Guards

Corner Set 4

Four pieces on the four points that meet the floor first. The cheapest place to add material.

USD 16

One-time purchase. No subscription.

Free standard shipping over USD 49.

Not sure it fits?

Fitted by you, to your case, following the steps below. A part that comes loose, or damage caused by fitting a part incorrectly, is not a product fault.

How it is built

Four moulded silicone corner guards with a 3 mm wall, each wrapping both faces of a corner and held by an adhesive pad plus its own tension. They fit the bottom corners of a case, which is where a dropped case lands.

Suits these shells

Hard shell, polycarbonate
Flexes under load and springs back. Takes surface scuffing more than cracking.
Hard shell, ABS
Stiffer and more brittle than polycarbonate. Corners are the usual failure point.
Aluminium frame
A full cover fits badly over the frame lip. Corner and edge guards suit these better.

Specification

Material
Moulded silicone, 3 mm wall, acrylic adhesive pads
Quantity
Four guards
Wall thickness
3 mm moulded silicone
Coverage
60 mm along each of the two faces
Fitting
Adhesive pad, self-fitted
SKU
C-01

Where those figures come from

Corner impact test
Free fall from 1.0 m onto a rigid steel plate, case loaded to 15 kg, impact on the lower shell corner, five repeats per sample, three samples, conducted at 23 °C.

Fitting

Three steps, no tools.

  1. 01Clean and dry the area of the case the part sits on. Room temperature, indoors.
  2. 02Line the part up dry first and check the fit before you commit any adhesive.
  3. 03Seat it, press it home along its full contact area, and leave it 24 hours before the case is handled.
Fitting sequence for Corner Set 4, shown in three stages.

Elsewhere in Corner & Edge Guards

Open the line
A moulded corner guard fitted to the bottom corner of a hard-shell case, its lip wrapping both faces.C-02

C · Corner & Edge Guards

Corner Set 8

All eight corners, not just the four on the bottom. Cases do not always land the way you packed them.

Material depth
3 mm

USD 26

A coil of hazard-orange edge trim partly unrolled, its cut end showing the profile.C-03Cut to size

C · Corner & Edge Guards

Edge Tape 3m

You decide which edges. Cut it to the run you want — and once it is cut, it cannot come back.

Material depth
4 mm

USD 22

Four moulded wheel shrouds arranged in a square, one flipped to show the clip geometry.C-04

C · Corner & Edge Guards

Wheel Guard Set

Wheels are the part that snaps. These sit around the housing without stopping the wheel turning.

Material depth
4 mm

USD 34