Skip to content

Free standard shipping on orders over 49 US Dollars. All prices on this site are in US Dollars.

Checkline
00 items in cart
A padded wrap sleeve fastened around a telescopic case handle bar, seam visible.
Three panels: a bare handle bar, the wrap sleeve opened flat beside it, the sleeve fastened on.
Three panels: a bare handle bar, the wrap sleeve opened flat beside it, the sleeve fastened on.
A reclaim carousel of near-identical dark cases with one marked case standing out.
A reclaim carousel of near-identical dark cases with one marked case standing out.

C · Corner & Edge Guards

Handle Wrap

The handle is the part people pull on hardest and the part that breaks second-most often.

USD 18

One-time purchase. No subscription.

Free standard shipping over USD 49.

Not sure it fits?

Fitted by you, to your case, following the steps below. A part that comes loose, or damage caused by fitting a part incorrectly, is not a product fault.

How it is built

A padded sleeve that closes around a telescopic bar or a side grab handle with a full-length hook-and-loop seam. 6 mm of foam under a woven face, so the load spreads over a wider area of the bar.

Suits these shells

Hard shell, polycarbonate
Flexes under load and springs back. Takes surface scuffing more than cracking.
Hard shell, ABS
Stiffer and more brittle than polycarbonate. Corners are the usual failure point.
Aluminium frame
A full cover fits badly over the frame lip. Corner and edge guards suit these better.
Soft side, fabric
Absorbs impact but scuffs and tears. Zippers and handles take the strain.

Specification

Material
600D woven face, 6 mm foam core, full-length hook-and-loop seam
Fits
Bars and grips 18–34 mm across
Length
150 mm
Foam core
6 mm
Fitting
Hook-and-loop, self-fitted, no tools
SKU
C-05

Where those figures come from

Foam density
Closed-cell EVA, apparent density measured per sample block at 23 °C and 50 % relative humidity, three samples averaged.

Fitting

Three steps, no tools.

  1. 01Clean and dry the area of the case the part sits on. Room temperature, indoors.
  2. 02Line the part up dry first and check the fit before you commit any adhesive.
  3. 03Seat it, press it home along its full contact area, and leave it 24 hours before the case is handled.
Fitting sequence for Handle Wrap, shown in three stages.

Elsewhere in Corner & Edge Guards

Open the line
A moulded corner guard fitted to the bottom corner of a hard-shell case, its lip wrapping both faces.C-01

C · Corner & Edge Guards

Corner Set 4

Four pieces on the four points that meet the floor first. The cheapest place to add material.

Material depth
3 mm

USD 16

A moulded corner guard fitted to the bottom corner of a hard-shell case, its lip wrapping both faces.C-02

C · Corner & Edge Guards

Corner Set 8

All eight corners, not just the four on the bottom. Cases do not always land the way you packed them.

Material depth
3 mm

USD 26

A coil of hazard-orange edge trim partly unrolled, its cut end showing the profile.C-03Cut to size

C · Corner & Edge Guards

Edge Tape 3m

You decide which edges. Cut it to the run you want — and once it is cut, it cannot come back.

Material depth
4 mm

USD 22