Skip to content

Free standard shipping on orders over 49 US Dollars. All prices on this site are in US Dollars.

Checkline
00 items in cart
A moulded corner guard fitted to the bottom corner of a hard-shell case, its lip wrapping both faces.
Three panels: a bare case corner, the guard aligned above it, the guard seated on the corner.
Three panels: a bare case corner, the guard aligned above it, the guard seated on the corner.
Three panels: a bare wheel housing, the shroud approaching, the shroud clipped on.
Three panels: a bare wheel housing, the shroud approaching, the shroud clipped on.

C · Corner & Edge Guards

Guard Kit Full

The three parts that fail most, covered in one go, for less than the three bought separately.

USD 52

One-time purchase. No subscription.

Free standard shipping over USD 49.

Contents bought separately: USD 68. This kit saves USD 16.

Not sure it fits?

Fitted by you, to your case, following the steps below. A part that comes loose, or damage caused by fitting a part incorrectly, is not a product fault.

How it is built

Four corner guards, four wheel shrouds and one handle wrap. These are the three places a checked case is most often returned damaged, and they are all self-fitted.

Suits these shells

Hard shell, polycarbonate
Flexes under load and springs back. Takes surface scuffing more than cracking.
Hard shell, ABS
Stiffer and more brittle than polycarbonate. Corners are the usual failure point.

Specification

Material
Moulded silicone, moulded TPU, woven face with 6 mm foam core
Contents
Corner Set 4, Wheel Guard Set, Handle Wrap
Covers
Four corners, four wheel housings, one handle
Fitting
All three self-fitted, no tools
SKU
C-06

Where those figures come from

Corner impact test
Free fall from 1.0 m onto a rigid steel plate, case loaded to 15 kg, impact on the lower shell corner, five repeats per sample, three samples, conducted at 23 °C.

Fitting

Three steps, no tools.

  1. 01Clean and dry the area of the case the part sits on. Room temperature, indoors.
  2. 02Line the part up dry first and check the fit before you commit any adhesive.
  3. 03Seat it, press it home along its full contact area, and leave it 24 hours before the case is handled.
Fitting sequence for Guard Kit Full, shown in three stages.

What is in this kit

  • Corner Set 4

    Four pieces on the four points that meet the floor first. The cheapest place to add material.

    USD 16

  • Wheel Guard Set

    Wheels are the part that snaps. These sit around the housing without stopping the wheel turning.

    USD 34

  • Handle Wrap

    The handle is the part people pull on hardest and the part that breaks second-most often.

    USD 18

Elsewhere in Corner & Edge Guards

Open the line
A moulded corner guard fitted to the bottom corner of a hard-shell case, its lip wrapping both faces.C-01

C · Corner & Edge Guards

Corner Set 4

Four pieces on the four points that meet the floor first. The cheapest place to add material.

Material depth
3 mm

USD 16

A moulded corner guard fitted to the bottom corner of a hard-shell case, its lip wrapping both faces.C-02

C · Corner & Edge Guards

Corner Set 8

All eight corners, not just the four on the bottom. Cases do not always land the way you packed them.

Material depth
3 mm

USD 26

A coil of hazard-orange edge trim partly unrolled, its cut end showing the profile.C-03Cut to size

C · Corner & Edge Guards

Edge Tape 3m

You decide which edges. Cut it to the run you want — and once it is cut, it cannot come back.

Material depth
4 mm

USD 22